...
首页> 外文期刊>Chemical engineering journal >Catalytic oxidative desulfurization performance of immobilized NMP center dot FeCl3 ionic liquid on gamma-Al2O3 support
【24h】

Catalytic oxidative desulfurization performance of immobilized NMP center dot FeCl3 ionic liquid on gamma-Al2O3 support

机译:固定的NMP中心点FECL3离子液体催化氧化脱硫性能在γ-Al2O3载体上

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

NMP center dot FeCI3 (NMP = N-methyl-2-pyrrolidone, C5H9NO) ionic liquid (IL) was effectively immobilized on gamma-Al2O3 as a support and examined in the catalytic oxidative deep desulfurization (ODS) of BT, DBT and 4,6-DMDBT from model oil employing 30 wt.% H2O2 as the oxidant reagent. The supported catalyst was prepared via a simple wet impregnation and the effective immobilization of IL was confirmed by FTIR, SEM, EDS, XRD, BET and BJH analysis. The maximum efficiency of 99% was achieved for ODS of DBT using supported IL at the loading amount of 10 wt.%, H2O2/sulfur molar ratio of 4, temperature of 40 degrees C, and duration of 90 min. The use of support material in this study resulted in using a lower amount of IL in ODS process. The ODS reactivity of the thiophenic compounds changed in the order of DBT > 4,6-DMDBT BT. The catalyst was recycled for several times and showed no significant loss in the activity. Furthermore, based on GC-MS analysis of the products, desulfurization mechanism was surveyed and a reasonable pathway was proposed. (C) 2017 Elsevier B.V. All rights reserved.
机译:NMP中心点FECI3(NMP = N-甲基-2-吡咯烷酮,C5H9NO)离子液体(IL)在γ-Al 2 O 3上有效地固定在γ-Al2O3上作为载体,并在BT,DBT和4的催化氧化深脱硫(ODS)中检查, 6-DMDBT从型油中使用30重量%的。%H2O2作为氧化剂试剂。通过简单的湿浸渍制备负载型催化剂,通过FTIR,SEM,EDS,XRD,BET和BJH分析证实IL的有效固定。使用支撑的IL的10重量%,H 2 O 2 /硫比为4,温度为40℃,持续90℃,达到最高效率为99%的效率为99%。在该研究中使用支持材料导致ODS过程中使用较低的IL。噻吩化合物的ODS反应性按DBT> 4,6-DMDBT BT的顺序改变。将催化剂再循环多次并在活动中没有显着损失。此外,基于产品的GC-MS分析,调查脱硫机制,提出了合理的途径。 (c)2017 Elsevier B.v.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号