首页> 外文期刊>ACS applied materials & interfaces >Preparation and Characterization of Polyhedral Oligomeric Silsesquioxane-Containing, Titania-Thiol-Ene Composite Photocatalytic Coatings, Emphasizing the Hydrophobic-Hydrophilic Transition
【24h】

Preparation and Characterization of Polyhedral Oligomeric Silsesquioxane-Containing, Titania-Thiol-Ene Composite Photocatalytic Coatings, Emphasizing the Hydrophobic-Hydrophilic Transition

机译:多面体低聚倍半硅氧烷的二氧化钛-硫醇-烯复合光催化涂层的制备和表征,着重于疏水-亲水转变

获取原文
获取原文并翻译 | 示例
       

摘要

Coatings prepared from titania-thiol-ene compositions were found to be both self-cleaning, as measured by changes in water contact angle, and photocatalytic toward the degradation of an organic dye. Stable titania-thiol-ene dispersions at approximately 2 wt % solids were prepared using a combination of high-shear mixing and sonication in acetone solvent from photocatalytic titania, trisilanol isobutyl polyhedral oligomeric silsesquioxane (Pass) dispersant, and select thiol-ene monomers, i.e., trimethylolpropane tris(3-mercaptopropionate) (TMPMP), pentaerythritol allyl ether (APE), and 1,3,5-triallyl-1,3,5-triazine-2,4,6(1H,3H,5H)-trione (TTT). The dispersed particle compositions were characterized by DLS and TEM. The synthetic methods employed yield a strongly bound particle/POSS complex, supported by IR, Si-29 NMR, and TGA. The factors of spray techniques, carrier solvent volatility, and particle size and size distributions, in combination, likely all contribute to the highly textured but uniform surfaces observed via SEM and AFM. Polymer composites possessed thermal transitions (e.g., T-g) consistent with composition. In general, the presence of polymer matrix provided mechanical integrity, without significantly compromising or prohibiting other critical performance characteristics, such as film processing, photocatalytic degradation of adsorbed contaminants, and the hydrophobic hydrophilic transition. In all cases, coatings containing photocatalytic titania were converted from superhydrophobic to superhydrophilic, as defined by changes in the water contact angle. The superhydrophilic state of samples was considered persistent, since long time durations in complete darkness were required to observe any significant hydrophobic return. In a preliminary demonstration, the photocatalytic activity of prepared coatings was confirmed through the degradation of crystal violet dye. This work demonstrates that a scalable process can be found to prepare titania-thiol-ene coatings having improved coating properties which also exhibit photocatalytic and self-cleaning attributes.
机译:发现由二氧化钛-硫醇-烯组合物制备的涂层既是自清洁的,如通过水接触角的变化所测量的,又是对有机染料降解的光催化的。使用高剪切混合和在丙酮溶剂中超声处理的组合,由光催化二氧化钛,三硅烷醇异丁基多面体低聚倍半硅氧烷(Pass)分散剂和选择的硫醇-烯单体(即高分子量的固体)制备稳定的约2 wt%的二氧化钛-硫醇-烯分散体,三羟甲基丙烷三(3-巯基丙酸酯)(TMPMP),季戊四醇烯丙基醚(APE)和1,3,5-三烯丙基-1,3,5-三嗪-2,4,6(1H,3H,5H)-三酮(TTT)。分散的颗粒组成通过DLS和TEM表征。所采用的合成方法可产生牢固结合的颗粒/ POSS络合物,并由IR,Si-29 NMR和TGA支持。喷涂技术,载体溶剂挥发性以及颗粒尺寸和尺寸分布等因素的综合作用,都可能有助于通过SEM和AFM观察到高度织构但均匀的表面。聚合物复合材料具有与组成一致的热转变(例如,T-g)。通常,聚合物基质的存在提供了机械完整性,而没有显着损害或阻止其他关键的性能特征,例如膜加工,吸附的污染物的光催化降解以及疏水性亲水转变。在所有情况下,根据水接触角的变化,含有光催化二氧化钛的涂料都从超疏水性转变为超亲水性。样品的超亲水状态被认为是持久的,因为需要长时间在完全黑暗的环境中观察任何明显的疏水性返回。在初步证明中,通过结晶紫染料的降解证实了所制备涂层的光催化活性。这项工作表明,可以发现可扩展的方法来制备具有改进的涂层性能的二氧化钛-硫醇-烯涂层,该涂层性能还表现出光催化和自清洁特性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号