首页> 外文期刊>ACS applied materials & interfaces >Pressure Measurement Based on a Multimode Phase Retarder Plastic Optical Fiber
【24h】

Pressure Measurement Based on a Multimode Phase Retarder Plastic Optical Fiber

机译:基于多模相位延迟器塑料光纤的压力测量

获取原文
获取原文并翻译 | 示例
       

摘要

This paper demonstrates a polarimetric pressure measurement using a multimode phase retarder plastic optical fiber fabricated from a birefringence-controllable copolymer. An optimal composition that gives the most pronounced response to pressure was studied by comparing the extinction ratio of fibers fabricated with different copolymer compositions. A simple sensor design with a single-fiber structure was proposed that has detection capabilities similar to those of the conventional dual-path structure of a Mach-Zehnder interferometer. A linear relationship between the fiber birefringence and the applied pressure was observed in a range from 0 to 0.06 MPa. A polarimetric sensitivity of 1.56 x 10~(-5) MPa~(-1) was obtained experimentally from the relationship between the birefringence and pressure.
机译:本文演示了使用由双折射可控共聚物制造的多模相位延迟器塑料光纤进行偏振压力测量。通过比较用不同共聚物组成制成的纤维的消光比,研究了对压力响应最明显的最佳组成。提出了一种具有单纤维结构的简单传感器设计,该传感器具有类似于Mach-Zehnder干涉仪的传统双路径结构的检测能力。观察到纤维双折射与施加压力之间的线性关系为0至0.06MPa。根据双折射和压力之间的关系,通过实验获得了1.56 x 10〜(-5)MPa〜(-1)的极化灵敏度。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号