Effect of gamma-irradiation on the mechanical behavior of EPDM rubber-recycled newsprint microfibers composites

摘要

Waste newsprint paper was collected from the local market and subjected to chemical pulping using 2 M NaOH. The fiber, after getting rid of water, was treated again using 2 M HCl solution for the same time period. The obtained newsprint microfibers (NPFs) were characterized by using scanning electron microscopy (SEM), X-ray diffraction (XRD), and Fourier transform infrared spectra. Then the dried and grounded NPF batch was mixed with ethylene propylene diene monomer (EPDM) rubber using different concentrations ranged from 5 to 50 phr. The prepared composites were irradiated by using gamma rays at different doses from 20 to 100 kGy. The mechanical properties of prepared EPDM/NPFs composites such as tensile strength (Ts), elongation at break (E-b%), tensile modulus (M-100), toughness (T-t), and crosslink density (Cd) were measured as a function of fiber contents and irradiation dose. The results indicated that the tensile strength (Ts) increases with increasing microfibers contents up to 10 phr and irradiation dose up to 40 kGy, while E-b% decreases as the fibers content and irradiation dose increase. M-100 and Cd values increase with increasing fibers content up 50 phr fibers and irradiation dose up to 60 kGy. The results also concluded that the toughness values of EPDM/NPFs composites reach its maximum degree when using 10 phr NPFs concentration and 60 kGy irradiation dose. J. VINYL ADDIT. TECHNOL., 25:198-212, 2019. (c) 2018 Society of Plastics Engineers