An Improved P-Phase Arrival Picking Method S/L-K-A with an Application to the Yongshaba Mine in China

摘要

Automatic microseismic P-phase arrival picking is paramount for microseismic event identification, event location and source mechanism analysis. The commonly used STA/LTA picker, PAI-K picker, AIC picker and three proposed pickers have been applied to determine the P-phase arrivals of 580 microseismic signals (the sampling frequency is 6000 Hz). These have been obtained from the Institute of Mine Seismology (IMS) acquisition system of the Yongshaba mine in China. Then, the six above-mentioned pickers have been compared in their picking accuracy, typical waveforms, signal-to-noise ratio (SNR) adaptabilities and quantitative evaluation. The results have shown that: (1) the triggered STA/LTA picker has a good picking stability but a low picking accuracy. While the PAI-K and the AIC pickers have a higher picking accuracy but a poorer picking stability compared with the triggered STA/LTA picker. Moreover, the AIC picker usually has a better picking result than the PAI-K picker; (2) the S/L-K-A picker significantly improves the STA/LTA, the PAI-K and the S/L + PAI-K pickers. Moreover, it obviously improves the AIC and the S/L + AIC pickers' large picking error ( 30 ms) signals; (3) the picking error ratios of the S/L-K-A picker within 10, 20 and 30 ms achieve 92.76, 95.86 and 97.41%, respectively. The S/L-K-A picker enhances the picking adaptability to different waveforms and SNRs. In conclusion, the S/L-K-A picker provides a new method for automatic microseismic P-phase arrival picking with a high accuracy and a good stability.