Performance of stone-plastic composites with different mix ratios during orthogonal cutting

摘要

The present study aimed to increase understanding of the machinability of stone-plastic materials with different mix ratios subjected to diamond planing. To that end, orthogonal cutting was carried out. Different stone-plastic materials were machined by diamond cutting tools to produce chips. Based on the results, four conclusions are drawn: (1) Among stone-plastic materials with decreasing polyvinyl chloride content ratio, the maximum cutting forces and fluctuation of dynamic forces show decreasing trends, and cutting stability increases. (2) The temperature of chips is slightly higher than that of tool edges; the cutting heat generated during machining is mainly absorbed by the chips of removed material and, to a lesser extent, stored in the tool edge. The type of stone-plastic material has a great effect on the changes in the temperatures of chip and tool edge. (3) With a decrease in polyvinyl chloride content, the chip shapes evolve from crack, to arc, and eventually to elemental chips. (4) The cutting quality of the machined surface improves with a decrease in the polyvinyl chloride content ratio of the stone-plastic materials.