Modification of Hypereutectic Al-20wt%Si Alloy Based on the Addition of Yttrium and Al-5Ti-1B Modifiers Mixing Melt

摘要

The effect of the addition of yttrium (Y) and Al-5Ti-1B modifiers mixing melt (3M) on the microstructure and mechanical properties of hypereutectic Al-20Si alloy was studied in the present work. The as-cast specimens were examined by scanning electron microscope equipped with energy spectrometer, electron probe microanalysis and X-ray diffraction. The results demonstrated that the morphology of primary Si could be refined from coarse irregular star-like/plate-like structures into fine blocks with the addition of 0.6wt% Y and 1.0wt% Al-5Ti-1B at 650 degrees C. The average grain size of primary Si was reduced from 82 to 29 mu m, and the aspect ratio was decreased from 1.81 to 1.47. Similarly, the eutectic Si structure was modified from coarse needlelike/flake-like structures into fine coral fibrous structures and partial granular structures, with the mean roundness of eutectic Si decreased from 7.8 to 2.32. In addition, the coarse -Al dendrites were significantly refined into the uniform equiaxed dendrites. With the refinement and homogenization of Si phases, the optimal modified alloy obtained the optimal ultimate tensile strength (UTS) and elongation (EL). The UTS was enhanced from 94 to 154MPa, and the EL was increased from initial 1.12 to 1.79%. Furthermore, the refinement and modification mechanism of the addition of yttrium and Al-5Ti-1B modifiers mixing melt on Al-20Si alloy were also discussed.