首页> 外文期刊>ChemSusChem >One-Pot 2-Methyltetrahydrofuran Production from Levulinic Acid in Green Solvents Using Ni-Cu/Al2O3 Catalysts
【24h】

One-Pot 2-Methyltetrahydrofuran Production from Levulinic Acid in Green Solvents Using Ni-Cu/Al2O3 Catalysts

机译:使用Ni-Cu / Al2O3催化剂的绿色溶剂中紫水酸的单壶2-甲基四氢呋喃产生

获取原文
获取原文并翻译 | 示例
       

摘要

The one-pot hydrogenation of levulinic acid to 2-methyltetrahydrofuran (MTHF) was performed using a series of Ni-Cu/Al2O3 catalysts in green solvents, such as water and biomass-derived alcohols. Ni/Al2O3 provided the highest activity, whereas Cu/Al2O3 was the most selective, reaching a 75% MTHF yield at 250 degrees C after 24h reaction time. Synergetic effects were observed when bimetallic Ni-Cu/Al2O3 catalysts were used, reaching a 56% MTHF yield in 5h at 250 degrees C for the optimum Ni/Cu ratio. Remarkably, these high yields were obtained using non-noble metal-based catalysts and 2-propanol as the solvent. The catalytic activity and selectivity results are correlated to temperature programmed reduction (TPR), XRD, and STEM characterization data, identifying the role associated with mixed Ni-Cu particles in addition to monometallic Cu and Ni.
机译:利用一系列Ni-Cu / Al 2 O 3催化剂如水和生物质衍生的醇。 Ni / Al2O3提供了最高的活性,而Cu / Al2O3是最选择性的,在24h反应时间后在250℃下达到75%的MTHF产率。 当使用双金属Ni-Cu / Al 2 O 3催化剂时,观察到协调效应,以250℃达到56%的56%,以获得最佳Ni / Cu的比例。 值得注意的是,使用非贵金属基催化剂和2-丙醇作为溶剂获得这些高产率。 催化活性和选择性结果与温度编程的减少(TPR),XRD和干性表征数据相关,除了单金属Cu和Ni之外还鉴定与混合的Ni-Cu颗粒相关的作用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号