首页> 外文期刊>Journal of Materials Science >Effects of VC additives on densification and elastic and mechanical properties of hot-pressed ZrB2-SiC composites
【24h】

Effects of VC additives on densification and elastic and mechanical properties of hot-pressed ZrB2-SiC composites

机译:VC添加剂对热压ZRB2-SiC复合材料致密化和弹性和力学性能的影响

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

In this study, highly dense ZrB2-20 vol% SiC composites with 3-10 wt% VC additives were prepared by hot-pressing at 1750 A degrees C for 1 h under a pressure of 20 MPa in a vacuum. The densification behavior and elastic and mechanical properties of the obtained composites were examined, and the effect of the VC content on the densification and the properties is analyzed. The addition of VC promotes the activation of densification mechanism at a lower temperature and inhibits the growth of ZrB2 and SiC grains during the sintering. In addition, the elastic moduli, hardness and fracture toughness that measured in the obtained composites are constant and independent of the VC content, with a shear modulus of similar to 220 GPa, Young's modulus of similar to 500 GPa, hardness of similar to 20 GPa and fracture toughness of similar to 4.4 MPa m(1/2). On the other hand, the flexural strength of the composites decreased as the VC content increased from 3 to 7 wt% and then it increased with further increasing the VC content to 10 wt%, with strength values of 620-770 MPa.
机译:在该研究中,通过在真空的压力下在20MPa的压力下在1750℃下热压1小时,制备具有3-10wt%VC添加剂的高度致密ZRB2-20 Vol%SiC复合材料。检查了所得复合材料的致密化行为和弹性和力学性能,分析了VC含量对致密化和性质的影响。在较低的温度下促进VC的加入促进致密化机制的活化,并抑制烧结过程中ZRB2和SiC颗粒的生长。此外,在所得复合材料中测量的弹性模量,硬度和断裂韧性是恒定的并且与VC含量无关,其剪切模量类似于220GPa,杨氏模量类似于500 GPa,类似于20GPa的硬度和骨折韧性类似于4.4MPa m(1/2)。另一方面,随着VC含量从3〜7wt%增加,复合材料的弯曲强度降低,然后将VC含量进一步增加至10wt%,其强度值为620-770MPa。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号