...
首页> 外文期刊>Surface & Coatings Technology >Electrochromic properties of nanostructured tungsten oxide films prepared by surfactant-assisted sol-gel process
【24h】

Electrochromic properties of nanostructured tungsten oxide films prepared by surfactant-assisted sol-gel process

机译:表面活性剂辅助溶胶-凝胶法制备的纳米结构氧化钨薄膜的电致变色性能

获取原文
获取原文并翻译 | 示例
           

摘要

Pristine and surfactant F-127 added tungsten oxide films have been prepared successfully by sol-gel method using PTA as the precursor sol. After annealing at 300°C, amorphous WO_3 films with or without F-127 additions were prepared. The F-127-added tungsten oxide films exhibit porous microstructure, which are affected by the amount of F-127 addition. Nanosized microstructure with pore size less than 10nm can be observed with small amount of F-127 addition (less than 0.06g/ml), where as larger spherical or tubular pores are found with superfluous F-127 addition (higher than 0.08g/ml). Not only the transmittance modulation but also the coloration efficiency can be improved by adding surfactant F-127. Tungsten oxide film with 0.10g/mlF-127 addition exhibits the best electrochromic performance with a transmittance modulation of 67.6% and a coloration efficiency of 38.3cm~2C~(-1).
机译:使用PTA作为前体溶胶,通过溶胶-凝胶法成功制备了添加了原始和表面活性剂F-127的氧化钨薄膜。在300℃下退火之后,制备添加或不添加F-127的非晶WO_3膜。添加了F-127的氧化钨膜表现出多孔的微观结构,其受F-127的添加量的影响。少量F-127加入(小于0.06g / ml)时,可以观察到孔径小于10nm的纳米级微观结构,而多余的F-127加入(高于0.08g / ml)时发现较大的球形或管状孔)。通过添加表面活性剂F-127,不仅可以提高透射率调制,而且可以提高着色效率。添加0.10g / mlF-127的氧化钨膜表现出最佳的电致变色性能,其透射比调制为67.6%,着色效率为38.3cm〜2C〜(-1)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号