首页> 外文期刊>Bioresource Technology: Biomass, Bioenergy, Biowastes, Conversion Technologies, Biotransformations, Production Technologies >Evaluation of culture conditions for cellulase production by two Trichoderma reesei mutants under solid-state fermentation conditions
【24h】

Evaluation of culture conditions for cellulase production by two Trichoderma reesei mutants under solid-state fermentation conditions

机译:固态发酵条件下两个里氏木霉突变体生产纤维素酶的培养条件的评估

获取原文
获取原文并翻译 | 示例
           

摘要

Response surface methodology (RSM) was used to evaluate the effects of fermentation parameters for cellulase production by Trichoderma reesei QM9414 and T reesei MCG77 in solid-state fermentation using rice bran as substrate. Initial pH, moisture content and temperature were optimized using filter paper activity (FPA) as response. Statistical analysis of the results for T reesei QM9414 showed that only moisture content had significant effect on cellulase activity and had a linear effect on enzyme activity (maximum enzyme activities were obtained at 70% moisture content). The results for T reesei MCG77 showed that temperature and moisture content were the most significant parameters for cellulase activity. The optimum cellulase production was in the temperature range of 25-30 degrees C and moisture content between 55% and 70%. After the optimization, the FPA in T reesei MCG77 was increased by 2.5 folds compared to that of T. reesei QM9414. (C) 2006 Elsevier Ltd. All rights reserved.
机译:响应面方法(RSM)用于评估以米糠为底物的固态发酵中里氏木霉QM9414和里氏木霉MCG77的发酵参数对纤维素酶生产的影响。使用滤纸活性(FPA)作为响应来优化初始pH,水分含量和温度。对里氏木霉QM9414结果的统计分析表明,仅水分含量对纤维素酶活性具有显着影响,而对酶活性具有线性影响(水分含量为70%时可获得最大的酶活性)。里氏木霉MCG77的结果表明,温度和水分含量是纤维素酶活性的最重要参数。最佳的纤维素酶生产温度为25-30摄氏度,水分含量为55%至70%。经过优化,与里氏木霉QM9414相比,里氏木霉MCG77中的FPA增加了2.5倍。 (C)2006 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号