...
首页> 外文期刊>Colloids and Surfaces, B. Biointerfaces >Solution properties and vesicle formation of rhamnolipid biosurfactants produced by Pseudomonas aeruginosa SP4
【24h】

Solution properties and vesicle formation of rhamnolipid biosurfactants produced by Pseudomonas aeruginosa SP4

机译:铜绿假单胞菌SP4产生的鼠李糖脂表面活性剂的溶液性质和囊泡形成

获取原文
获取原文并翻译 | 示例

摘要

A biosurfactant produced by Pseudomonas aeruginosa strain SP4 was previously reported as a mixture of 11 types of rhamnolipid compounds. Among them, the major component in the biosurfactant was characterized as L-rhamnosyl-3-hydroxydecanoyl-3-hydroxydecanoate, or monorhamnolipid (Rha-C-10-C-10). In this present study, solution properties of the biosurfactant were investigated in a phosphate-buffer saline (PBS) solution (pH 7.4) by using surface tension, turbidity, electrical conductivity, and dynamic light scattering (DLS) measurements. It was found that spherical biosurfactant vesicles of various sizes (ranging from 50 to larger than 250 nm) were spontaneously formed at a biosurfactant concentration greater than its critical micelle concentration (CIVIC), which was 200 mg/l. The encapsulation efficiency (E%) of the biosurfactant vesicles was preliminarily studied by using Sudan 111, a water-insoluble dye, as a model hydrophobic substance. The obtained results showed that the vesicle formed in the PBS solution at a biosurfactant concentration of 1280 mg/l could entrap about 10% of the initial hydrophobic dye concentration. The effects of salt and alcohol on the vesicle formation of the biosurfactant and its encapsulation efficiency were also observed by using sodium chloride (NaCl) and ethanol (C2H5OH), respectively. In the presence of either NaCl or C2H5OH. the vesicle size was reduced from larger than 250 nm to 50-250 nm. The encapsulation efficiency of the biosurfactant vesicle was slightly influenced by the addition of NaCl, but was significantly increased, up to nearly 30%. in the presence of C2H5OH.
机译:先前报道由铜绿假单胞菌菌株SP4产生的生物表面活性剂是11种鼠李糖脂化合物的混合物。其中,生物表面活性剂的主要成分为L-鼠李糖基-3-羟基癸酰基-3-羟基癸酸酯或单鼠李糖脂(Rha-C-10-C-10)。在本研究中,通过使用表面张力,浊度,电导率和动态光散射(DLS)测量,在磷酸盐缓冲盐水(PBS)溶液(pH 7.4)中研究了生物表面活性剂的溶液性质。发现以大于其临界胶束浓度(CIVIC)的200mg / l的生物表面活性剂浓度自发形成各种大小的球形生物表面活性剂囊泡(范围从50nm至大于250nm)。通过使用水不溶性染料苏丹111作为模型疏水性物质,初步研究了生物表面活性剂囊泡的包封率(E%)。获得的结果表明,以1280 mg / l的生物表面活性剂浓度在PBS溶液中形成的囊泡可捕获约10%的初始疏水染料浓度。分别使用氯化钠(NaCl)和乙醇(C2H5OH),还观察到了盐和酒精对生物表面活性剂囊泡形成的影响及其包封效率。在NaCl或C2H5OH存在下。囊泡尺寸从大于250 nm减小到50-250 nm。加入NaCl会对生物表面活性剂囊泡的包封效率产生轻微影响,但明显提高,最高可达近30%。在C 2 H 5 OH存在下。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号