首页> 外文期刊>Journal of Materials Science >Microwave dielectric properties of ceramics with compositions along the La2/3TiO3(STAB)-LaAlO3 tie line
【24h】

Microwave dielectric properties of ceramics with compositions along the La2/3TiO3(STAB)-LaAlO3 tie line

机译:沿La2 / 3TiO3(STAB)-LaAlO3键合线组成的陶瓷的微波介电性能

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

The stabilization of La2/3TiO3 in the perovskite structure by 4 mol% LaAlO3 resulted in maximum values for the relative permittivity (k'approximate to 72) and temperature coefficient of resonant frequency (tau(f) = 123 ppmK(-1)). The Q-value (quality factor) of these ceramics were over 5300 measured at 4.5 GHz. Higher contents of LaAlO3 cause a decrease in both the permittivity and tau(f) values, accompanied by an increase in the Q-value. Typical values measured at 6.0 GHz for ceramics with the composition 70 mol% La2/3TiO3-30 mol% LaAlO3 are k' > 44, tau(f) = +7 ppmK(-1) and Q > 5500. The results depend on the processing parameters. The sintering temperature increases with increasing LaAlO3 content. An oxidizing sintering atmosphere improves the Q-value, whereas the permittivity and tau(f) are not significantly affected. [References: 17]
机译:La2 / 3TiO3在钙钛矿结构中的稳定度为4 mol%LaAlO3,导致相对介电常数(k'约为72)和共振频率温度系数的最大值(tau(f)= 123 ppmK(-1))。这些陶瓷的Q值(品质因数)在4.5 GHz下测得超过5300。 LaAlO3含量较高会导致介电常数和tau(f)值均降低,同时Q值也会增加。对于组成为70 mol%La2 / 3TiO3-30 mol%LaAlO3的陶瓷,在6.0 GHz下测得的典型值为k'> 44,tau(f)= +7 ppmK(-1),Q> 5500。处理参数。烧结温度随LaAlO3含量的增加而增加。氧化性烧结气氛改善了Q值,而介电常数和tau(f)并未受到明显影响。 [参考:17]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号