首页> 外文期刊>Journal of Materials Science >RELATION BETWEEN AXIAL COMPRESSIVE STRENGTH OF REINFORCING FIBRES AND FIBRE DIAMETER
【24h】

RELATION BETWEEN AXIAL COMPRESSIVE STRENGTH OF REINFORCING FIBRES AND FIBRE DIAMETER

机译:增强纤维的轴心抗压强度与纤维直径的关系

获取原文
获取原文并翻译 | 示例
           

摘要

Attempts were made to estimate the fibre axial compressive strength of pitch-based graphitized and polyarylate fibres, and the relationship between the compressive strength and fibre diameter was investigated. The estimated compressive strength of fibres decreases with increasing temperature. This decrease in compressive strength may be accounted for by a decrease in the radial compressing force. There is a linear relationship between the estimated compressive strength and radial compressing force in a temperature range from room temperature to 80 degrees C. The real compressive strength of the fibres, determined by extrapolating this straight line until the radial compressing force is zero, increases with decreasing fibre diameter, but remains almost unchanged at a diameter range smaller than 10 mu m. In order to obtain reinforcing fibres having a higher compressive strength, it will be necessary to prepare fibres having a diameter smaller than 10 mu m. [References: 35]
机译:尝试估算沥青基石墨化和聚芳酯纤维的纤维轴向抗压强度,并研究了抗压强度与纤维直径之间的关系。估计的纤维抗压强度随温度升高而降低。抗压强度的这种降低可以通过径向压缩力的降低来解决。在从室温到80摄氏度的温度范围内,估算的抗压强度与径向压缩力之间存在线性关系。通过将直线外推直到径向压缩力为零,可以确定纤维的实际压缩强度,随纤维直径减小,但在小于10微米的直径范围内几乎保持不变。为了获得具有较高抗压强度的增强纤维,必须制备直径小于10μm的纤维。 [参考:35]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号