首页> 外文期刊>Journal of Chemical and Engineering Data: the ACS Journal for Data >Density, Viscosity, Vapor-Liquid Equilibrium, and Excess Molar Enthalpy of [Chloroform + Methyl tert-Butyl Ether]
【24h】

Density, Viscosity, Vapor-Liquid Equilibrium, and Excess Molar Enthalpy of [Chloroform + Methyl tert-Butyl Ether]

机译:[氯仿+甲基叔丁基醚]的密度,粘度,蒸气-液体平衡和过量的摩尔焓

获取原文
获取原文并翻译 | 示例
           

摘要

Density and viscosity measurements in the T = (273.15 to 318.15) K range of pure chloroform and methyl tert-butyl ether (MTBE), as well as of the binary system [x1 chloroform + (1 - x1) MTBE] over the whole concentration range at T = 293.15 K, were made. The experimental results for the pure components were fitted to empirical equations, which permit the calculation of these properties in the studied temperature range. Calculated values are in agreement with the experimental ones. Data of the binary mixture were further used to calculate the excess molar volume and viscosity deviations. The excess molar enthalpy at T = (303 ± 1) K and vapor-liquid equilibrium measurements at T = (303.15 ± 0.05) K were also measured for the binary system. These last experimental results were used to calculate activity coefficients, the excess molar Gibbs energy, and excess molar entropy. This binary system shows strong negative deviations from ideality and exhibits a minimum pressure azeotrope, whose coordinates are: P = (26.30 ± 0.05) kPa and x1 = (0.586 ± 0.002). Excess or deviation properties were fitted to the Redlich-Kister polynomial relation to obtain their coefficients and standard deviations. The vapor pressure of pure MTBE over the P = [(20.00 to 97.20) ± 0.05] kPa range was also measured.
机译:在整个浓度下,纯氯仿和甲基叔丁基醚(MTBE)以及二元体系[x1氯仿+(1-x1)MTBE]的T =(273.15至318.15)K范围内的密度和粘度测量在T = 293.15 K的范围内。纯组分的实验结果适合经验公式,从而可以在研究的温度范围内计算这些特性。计算值与实验值一致。二元混合物的数据进一步用于计算过量的摩尔体积和粘度偏差。对于二元系统,还测量了T =(303±1)K时的过量摩尔焓和T =(303.15±0.05)K时的气液平衡测量值。这些最后的实验结果用于计算活度系数,过量的摩尔吉布斯能量和过量的摩尔熵。该二元系统显示出与理想情况之间的强烈负偏差,并显示出最小压力共沸物,其坐标为:P =(26.30±0.05)kPa和x1 =(0.586±0.002)。将过量或偏差属性拟合到Redlich-Kister多项式关系,以获得其系数和标准偏差。还测量了纯MTBE在P = [(20.00至97.20)±0.05] kPa范围内的蒸气压。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号