...
首页> 外文期刊>Journal of Applied Polymer Science >Graft Copolymerization of Methyl Acrylate onto Sago Starch Using Ceric Ammonium Nitrate as an Initiator
【24h】

Graft Copolymerization of Methyl Acrylate onto Sago Starch Using Ceric Ammonium Nitrate as an Initiator

机译:以硝酸铈铵为引发剂将丙烯酸甲酯接枝到西米淀粉上

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The graft copolymerization of methyl acrylate onto sago starch was carried out by af free radical initiating process. The free radicals were produced by the chemical initiation method in which ceric ammonium nitrate was used as an initiator. It was found that the percentages of grafting, grafting efficiency, and rate of grafting were all dependent on the concentration of ceric ammonium nitrate (CAN), methyl acrylate (MA), sago starch (AGU), mineral acid (H_2SO_4), and reaction temperature and period. The variables affecting the graft copolymerization were thoroughly examined. The optimum yield of grafting was obtained when the concentration of CAN, MA, AGU, and H_2SO_4 were used at 8.77×10~(-3), 0.803, 0.135, and 0.175 mol L~(-1), respectively. The optimum reaction temperature and period were 50deg C and 60 min, respectively. The rate of graft polymerizaiton was explored on the basis of experimental results and reaction mechanism. The evidence of grafted copolymers was investigated by using FTIR spectroscopy, TG, and DSC analysis.
机译:通过自由基引发法将丙烯酸甲酯接枝到西米淀粉上。通过化学引发方法产生自由基,其中使用硝酸铈铵作为引发剂。结果表明,接枝率,接枝效率和接枝率均取决于硝酸铈铵(CAN),丙烯酸甲酯(MA),西米淀粉(AGU),无机酸(H_2SO_4)的浓度和反应温度和周期。彻底检查了影响接枝共聚的变量。当CAN,MA,AGU和H_2SO_4的浓度分别为8.77×10〜(-3),0.803、0.135和0.175 mol L〜(-1)时,可获得最佳的接枝产率。最佳反应温度和时间分别为50℃和60分钟。在实验结果和反应机理的基础上,探讨了接枝聚合的速率。通过使用FTIR光谱,TG和DSC分析研究了接枝共聚物的证据。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号