...
首页> 外文期刊>Journal of Applied Polymer Science >Study of cryostructuration of polymer systems. XVII. Poly(vinyl alcohol) cryogels: Dynamics of the cryotropic gel formation
【24h】

Study of cryostructuration of polymer systems. XVII. Poly(vinyl alcohol) cryogels: Dynamics of the cryotropic gel formation

机译:聚合物系统的冷冻结构研究。十七。聚乙烯醇低温凝胶:低温凝胶形成的动力学

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Freeze-thaw treatment of concentrated (> 5 g/dL) aqueous solutions of poly(vinyl alcohol) (PVA) (MW 115,000; DD approximate to 100%) resulted in the formation of opaque gels. The extent of such a cryostructuration process was exhibited in the rheological properties of similar PVA cryogels. The gels' strength depended on the initial polymer concentration in the solution to be frozen and on the conditions of a cryogenic influence. The key factor was the defrostation dynamics: the slower the thawing rate, the stronger the cryogel sample formed, provided other parameters of the process were identical. The observation for the kinetics of the freeze-thaw-induced gel formation revealed the extreme character of the temperature dependence of the efficacy of PVA cryotropic gelation, the maximum point being in the vicinity of -2 degrees C. It was shown that the effect of the strengthening of PVA cryogels prepared by means of a single-cycle cryogenic treatment could be reached either with use of as slow as possible thawing regimes, or by the prolonged frozen storage of the samples at "high" subzero temperatures. (C) 2000 John Wiley & Sons, Inc. [References: 27]
机译:聚乙烯醇(PVA)(MW 115,000; DD大约为100%)的浓(> 5 g / dL)浓水溶液的冻融处理导致形成不透明的凝胶。这种低温结构化过程的程度在相似的PVA低温凝胶的流变特性中得以体现。凝胶的强度取决于要冷冻的溶液中的初始聚合物浓度和低温影响的条件。关键因素是除霜动力学:解冻速率越慢,形成的冷冻凝胶样品越强,条件是该过程的其他参数相同。冻融诱导的凝胶形成的动力学的观察揭示了PVA低温凝胶化功效的温度依赖性的极端特征,最大点在-2℃附近。通过使用尽可能缓慢的解冻方案,或者通过在“高”低于零温度下长时间冷冻储存,可以达到通过单循环低温处理制备的PVA冷冻凝胶的增强。 (C)2000 John Wiley&Sons,Inc. [参考:27]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号