首页> 外文期刊>The Journal of Chemical Thermodynamics >Compressed liquid densities and excess molar volumes for (CO2 + 1-pentanol) binary system at temperatures from 313 to 363 K and pressures up to 25 MPa
【24h】

Compressed liquid densities and excess molar volumes for (CO2 + 1-pentanol) binary system at temperatures from 313 to 363 K and pressures up to 25 MPa

机译:(CO2 + 1-戊醇)二元系统在313至363 K的温度和最高25 MPa的压力下的压缩液体密度和过量摩尔体积

获取原文
获取原文并翻译 | 示例
           

摘要

Measurements of compressed liquid densities for 1-pentanol and for {CO2 (1) + 1-pentanol (2)} system were carried out at temperatures from 313 K to 363 K and pressures up to 25 MPa. Densities were measured for binary mixtures at 10 different compositions, x1 = 0.0816, 0.1347, 0.3624, 0.4651, 0.6054, 0.7274, 0.8067, 0.8573, 0.9216, and 0.9757. A vibrating tube densimeter was used to perform density measurements using two reference calibration fluids. The uncertainty is estimated to be better than ±0.2 kg · m?3 for the experimental density measurements. For each mixture and for 1-pentanol, the experimental densities were correlated using an explicit volume equation of six parameters and an 11-parameter equation of state (EoS). Excess molar volumes were determined for the (CO2 + 1-pentanol) system using 1-pentanol densities calculated from the 11-parameter EoS and CO2 densities calculated from a multiparameter reference EoS.
机译:1-戊醇和{CO2(1)+ 1-戊醇(2)}系统的压缩液体密度的测量是在313 K至363 K的温度和最高25 MPa的压力下进行的。测量了10种不同组成的二元混合物的密度,x1 = 0.0816、0.1347、0.3624、0.4651、0.6054、0.7274、0.8067、0.8573、0.9216和0.9757。振动管密度计用于使用两种参考校准液进行密度测量。对于实验密度测量,不确定性估计要好于±0.2 kg·m?3。对于每种混合物和1-戊醇,使用包含六个参数的显式体积方程式和状态参数(EoS)的11参数来关联实验密度。使用从11参数EoS计算得出的1-戊醇密度和从多参数参考EoS计算得出的CO2密度,确定(CO2 + 1-戊醇)系统的过量摩尔体积。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号