Development of an automated measurement system diffusion scrubber and high-performance liquid chromatography for the monitoring of formaldehyde and acetaldehyde in automotive exhaust gas

摘要

An automated measurement system for monitoring formaldehyde (HCHO) and acetaldehyde (CH3CHO) in automotive exhaust gas by using a diffusion scrubber in combination with high-performance liquid chromatography (HPLC) was developed. HCHO and CH3CHO are effectively collected by the diffusion scrubber, which consists of a hydrophobic porous PTFE tube disposed concentrically within a Pyrex-glass tube and a scrubbing solution. 2,4-Dinitrophenylhydrazine is used as the scrubbing solution for trapping HCHO and CH3CHO, which are derivatized to formaldehyde 2,4-dinitrophenylhydrazone (DNPH-HCHO) and acetaldehyde 2,4-dinitrophenylhydrazone (DNPH-CH3CHO), respectively, with phosphoric acid as an acid catalyst. After the collection of the gas sample, the sample solution in the diffusion scrubber is injected into the HPLC system and DNPH-HCHO and DNPH-CH3CHO are separated and determined. All measurement operations are sequenced by a programmable controller and an automated continuous measurement can be performed at 10 min intervals. The collection efficiencies of HCHO and CH3CHO were higher than 97% at a gas flow rate of 0.2 1 min(-1). The detection limit (3 sigma of the blank value) was 0.001 ppm v/v for HCHO and CH3CHO for a 1.6 1 gas sample volume. No interference of co-existing nitrogen dioxide (NO2) in the collection of HCHO and CH3CHO was observed. The average concentration of HCHO in the exhaust gas from methanol-fueled vehicles was 77.3 ppm v/v (n = 5) in the cold-phase mode when engines were first started. In the hot-phase mode, the average concentration of HCHO was 3.3 ppm v/v (n = 15). The concentrations of HCHO measured by this automated measurement system were in good agreement with those obtained using the impinger-HPLC method. [References: 28]