Control of shrinkage and residual styrene of unsaturated polyester resins cured at low temperatures:I.Effect of curing agents

摘要

In low temperature molding processes,control of resin shrinkage and residual monomer is an important concern.The presence of low profile additives(LPAs) can reduce the shrinkage of unsaturated polyester (UP)/styrene (St) resins under proper processing conditions but may increase the residual styrene content.A systematic study was carrie dout to investigate the effect of the initator system and reaction temperature on sample morphology,final resin conversion,and resin shrinkage of UP resins with LPA.It was found that the final conversion of the resin system could be improved by using dual initiators.The effect is more obvious at low temperatures.Volume shrinkage measurements of the resin system initiated with dual initiators revealed that good LPA performance was achieved at low (e.g.35degC) and high (e.g.100degC) temperatures but not at intermediate ones.This can be explained by how temperature affects phase separation,reaction kinetics in the LPA-rich and UP-rich phases,micro-void formation,and thermal expansion.