...
首页> 外文期刊>Thin Solid Films >Thermal expansion coefficient of amorphous carbon nitride thin films deposited by glow discharge
【24h】

Thermal expansion coefficient of amorphous carbon nitride thin films deposited by glow discharge

机译:通过辉光放电沉积的非晶氮化碳薄膜的热膨胀系数

获取原文
获取原文并翻译 | 示例

摘要

The thermal expansion coefficient of a-CN_x,:H thin films was determined by the thermally induced bending technique. The films were deposited by glow discharge under methane and nitrogen atmosphere, and analyzed by FTIR and Raman spectroscopies, nanohardness, and stress measurements. Drastic changes of the film structure were observed as a result of the nitrogen incorporation, from 0 to 7%. The increase of nitrogen concentration reduces the deposition rate, stress, hardness, and the elastic constant of the films. It was also observed that the thermal expansion coefficient has a significant increase from approximately 2-9X10~(-6)/K, which was associated with the increase in the sp~2 concentration induced by the N incorporation, and with the increase in the concentration of C-N bonds. In spite of that, stable and thick (~2μm) films were deposited at moderate deposition rate (0.3 nm/s), relatively high hardness (13 GPa), and low stress (0.6 GPa).
机译:a-CN_x,:H薄膜的热膨胀系数通过热诱导弯曲技术确定。膜在甲烷和氮气气氛下通过辉光放电沉积,并通过FTIR和拉曼光谱,纳米硬度和应力测量进行分析。由于氮的引入,观察到膜结构的剧烈变化,从0到7%。氮浓度的增加降低了膜的沉积速率,应力,硬度和弹性常数。还观察到,热膨胀系数从大约2-9X10〜(-6)/ K显着增加,这与氮掺入引起的sp〜2浓度的增加以及氮的增加有关。 CN键的浓度。尽管如此,仍以中等沉积速率(0.3 nm / s),相对较高的硬度(13 GPa)和较低的应力(0.6 GPa)沉积了稳定且厚的膜(〜2μm)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号