...
首页> 外文期刊>Thin Solid Films >Hot-wire CVD deposited n-type μc-Si films for μc-Si/c-Si heterojunction solar cell applications
【24h】

Hot-wire CVD deposited n-type μc-Si films for μc-Si/c-Si heterojunction solar cell applications

机译:用于μc-Si/ c-Si异质结太阳能电池应用的热线CVD沉积n型μc-Si膜

获取原文
获取原文并翻译 | 示例
           

摘要

Phosphorous-doped microcrystalline silicon (μc-Si) films were prepared using hot-wire chemical vapor deposition (HWCVD). Structural, electrical and optical properties of these thin films were systematically studied as a function of PH_3 gas mixture ratio. We report recent results for p-type crystalline silicon-based heterojunction (HJ) solar cells using the HWCVD n-μc-Si film to form an n-p junction. The surface morphology of the crystalline Si substrate after hydrogen treatment was examined using atomic force microscopy. A transfer length method was used to modify the indium-tin-oxide (ITO) deposition parameters in order to reduce front ITO-μc-Si contact resistance. In our best solar cell sample (1 cm~2) without any buffer layer, the conversion efficiency of 15.1% has been achieved with an open circuit voltage of 0.615 V, fill factor of 0.71 and short circuit current density of 34.6 mA/cm~2 under 100 mW/cm~2 condition. The spectral response of this cell will also be discussed.
机译:使用热线化学气相沉积(HWCVD)制备了磷掺杂的微晶硅(μc-Si)膜。系统研究了这些薄膜的结构,电学和光学性质随PH_3气体混合比的变化。我们报告使用HWCVDn-μc-Si膜形成n-p结的p型晶体硅基异质结(HJ)太阳能电池的最新结果。使用原子力显微镜检查氢处理后的结晶Si衬底的表面形态。为了降低正面ITO -μc-Si的接触电阻,使用了传输长度方法来修改铟锡氧化物(ITO)的沉积参数。在我们最好的没有任何缓冲层的太阳能电池样品(1 cm〜2)中,开路电压为0.615 V,填充系数为0.71,短路电流密度为34.6 mA / cm〜,转换效率达到了15.1%。在100 mW / cm〜2条件下为2。还将讨论该单元的光谱响应。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号