首页> 外文期刊>Thin Solid Films >Atomic layer deposition of Al2O3 and Al2O3/TiO2 barrier coatings to reduce the water vapour permeability of polyetheretherketone
【24h】

Atomic layer deposition of Al2O3 and Al2O3/TiO2 barrier coatings to reduce the water vapour permeability of polyetheretherketone

机译:Al2O3和Al2O3 / TiO2阻隔涂层的原子层沉积以降低聚醚醚酮的水蒸气渗透性

获取原文
获取原文并翻译 | 示例
       

摘要

Wedemonstrate significantly enhanced barrier properties of polyetheretherketone (PEEK) against water vapour penetration by depositing Al2O3 or Al2O3/TiO2 nanofilms grown by atomic layer deposition (ALD). Nanoindentation analysis revealed good adhesion strength of a bilayer Al2O3/TiO2 coating to PEEK, while the single layer Al2O3 coating displayed flaking and delamination. We identified three critical design parameters for achieving the optimum barrier properties of ALDAl(2)O(3)/TiO2 coatings on PEEK. These are a minimum total thickness dependent on the required water vapour transmission rate, the use of an Al2O3/TiO2 bilayer coating and the application of the coating to both sides of the PEEK film. Using these design parameters, we achieved a reduction in moisture permeability of PEEK of over two orders of magnitude while maintaining good adhesion strength of the polymer-thin film system. (C) 2015 Elsevier B.V. All rights reserved.
机译:Wedemon通过沉积通过原子层沉积(ALD)生长的Al2O3或Al2O3 / TiO2纳米膜,显着增强了聚醚醚酮(PEEK)对水蒸气渗透的阻隔性能。纳米压痕分析表明双层Al2O3 / TiO2涂层与PEEK的粘合强度良好,而单层Al2O3涂层则显示出剥落和分层。我们确定了三个关键设计参数,以实现PEEK上的ALDAl(2)O(3)/ TiO2涂层的最佳阻隔性能。这些是最小的总厚度,取决于所需的水蒸气透过率,Al2O3 / TiO2双层涂层的使用以及该涂层在PEEK膜的两面上的应用。使用这些设计参数,我们实现了PEEK透湿性下降两个数量级以上,同时保持了聚合物薄膜系统的良好粘合强度。 (C)2015 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号