'Easi Build' 80m Transceiver

摘要

Having concluded the electrical side of the transceiver, we move on to aspects of its construction. As stated previously, this project was designed for easy construction. Mechanical work has been minimized; nonetheless some is required. The copper-clad board should be double-sided fi-breglass, but SRBP could be used. This would be easier to cut, but the end result is not as rigid. If you have, or if you know someone who has access to a workshop guillotine, then this part of the project could be very easy. If not, you will have to cut the board by hand. Possibly the best way to do this is clamp it in a vice between two pieces of angle iron, which are then used as a cutting guide.