AlInP X-ray photodiodes without incomplete charge collection noise

摘要

Previously, an Al_(0.52)In_(0.48)P p~+-i-n~+ spectroscopic photon counting X-ray photodiode with 2 μm thick i layer (200 μm diameter) was shown to suffer from energy-dependent incomplete charge collection noise (Lioliou et al., 2019). Subsequent measurements on a larger (400 μm diameter) Al_(0.52)In_(0.48)P p~+-i-n~+ photodiode (reported here) revealed the presence of even greater incomplete charge collection noise. Given these findings, an expectation would have been that thicker Al_(0.52)In_(0.48)P structures (which would be required for efficient absorption of all but the softest X-rays) would have a greater incomplete charge collection noise contribution, thus suggesting that thick Al_(0.52)In_(0.48)P photodiodes may be of limited practicality as high performance detectors for photon counting X-ray spectroscopy. However, two new Al_(0.52)In_(0.48)P p~+-i-n~+ photodiodes (with 6 μm i layers) were fabricated from material grown by the same technique (metalorganic vapour phase epitaxy) in the same reactor, and are now shown here to exhibit no signs of detectable incomplete charge collection noise under the illumination of X-ray photons of energy 4.95 keV to 21.17 keV. As such, now that greater experience has been built with Al_(0.52)In_(0 48)P, concerns about incomplete charge collection noise in X-ray detectors made from the material appear to have been unwarranted; the path towards thick Al_(0.52)In_(0.48)P X-ray detectors is now clear.