Influence of forming method on the tensile and fatigue properties of Ti-6A1-4V sheet for helicopter erosion shield applications

摘要

The effect that different forming methods (i.e. hot and super-plastic forming) have on the static, micro structural and fatigue properties of Ti-6A1-4V sheet has been studied. From the test data it is clear that the type of forming method used can have an influence on the resultant static and fatigue properties. Although manufacturing differences used by each forming method preclude direct comparison to be made between forming techniques it would appear high cycle fatigue (HCF) and 0.2% proof stress of Hot Stretch Formed (HSF) annealed Ti-6A1-4V was shown to be on average 20% and 10% higher respec tively than that produced by Super Plastic Forming (SPF). Based on the results contained within this paper it would appear that the factors responsible for the observed differences were primarily microstructural, in which the higher the forming temperature employed, the coarser the primary alpha grain size and the lower the resultant static and dynamic properties.