首页> 外文期刊>International Journal of Electrical Power & Energy Systems >An optimal reactive power control method for distribution network with soft normally-open points and controlled air-conditioning loads
【24h】

An optimal reactive power control method for distribution network with soft normally-open points and controlled air-conditioning loads

机译:常开点柔和空调负荷可控的配电网无功优化控制方法

获取原文
获取原文并翻译 | 示例
       

摘要

The paper proposes an optimal reactive power control method for distribution systems with soft normally-open points (SNOP) and considering the direct load control (DLC) of thermostatically controlled air-conditioning loads. The starting voltage constraints of aggregate air-conditioning loads connected into a distribution network is studied according to the direct control mode and the starting characteristic of air-conditioning load. Using the flexible regulating capacity of power flow of SNOP, an optimal model of reactive power flow for distribution systems with SNOP is established to meet the voltage quality of sensitive loads and the starting requirements of aggregate air-conditioning loads. In the model, the load balancing commands of different DLC aggregators, the on/off status of thermostatically controlled air conditioner, the power regulating command of SNOP, the voltage adjusting and reactive power compensation devices are comprehensively controlled in the constraints of reduction balance and starting voltage of air-conditioning loads, as well as the conventional network and voltage constraints. And a multi-objective functions are developed for the objectives of solving the low-voltage problems, minimizing the comfort impacts on users of air-conditioning and minimizing the active power loss of distribution systems. Finally, the simulation results of a practical 53-bus 10 kV distribution system demonstrate the accuracy and effectiveness of the proposed method.
机译:针对具有软常开点(SNOP)的配电系统,并考虑了恒温控制的空调负荷的直接负荷控制(DLC),提出了一种最优的无功控制方法。根据直接控制方式和空调负载的启动特性,研究了接入配电网的总空调负载的启动电压约束。利用SNOP潮流的灵活调节能力,建立了SNOP配电系统无功潮流的最优模型,以满足敏感负荷的电压质量和总空调负荷的启动要求。在该模型中,在减少平衡和启动的约束下,综合控制了不同DLC聚合器的负载平衡命令,恒温空调的开/关状态,SNOP的功率调节命令,电压调节和无功补偿装置。空调负载的电压,以及常规网络和电压限制。为了解决低压问题,最小化舒适性对空调用户的影响以及最小化配电系统的有功功率,开发了多目标功能。最后,一个实际的53总线10 kV配电系统的仿真结果证明了该方法的准确性和有效性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号