首页> 外文期刊>Fusion Engineering and Design >Influence of blistering on deuterium retention in tungsten irradiated by high flux deuterium 10-100 eV plasmas
【24h】

Influence of blistering on deuterium retention in tungsten irradiated by high flux deuterium 10-100 eV plasmas

机译:起泡对高通量氘10-100 eV等离子体辐照钨中氘保留的影响

获取原文
获取原文并翻译 | 示例
       

摘要

The influence of blistering on deuterium retention in polycrystalline tungsten (W) has been studied at incident energies of tens of eV and a fixed incident flux of 1 x 10~(22) D/m~2/s. The surface morphology was observed using scanning electron microscopy (SEM) and the deuterium retention in the irradiated samples measured using thermal desorption spectrometry (TDS). The results indicate that at substrate temperature around 400-500 K dense and high dome-shaped blisters appeared at the surface and the deuterium retention also reached its maxima. The blisters then became lower and sparse and finally disappeared at 900 K. Additionally, the D retention decreased to a quite low level above 700 K. Thermal desorption spectra of the deuterium in the irradiated samples showed four peak temperatures as a function of the substrate temperature during irradiation, indicating different types of trapping sites.
机译:研究了在数十eV的入射能量和1 x 10〜(22)D / m〜2 / s的固定入射通量下,起泡对多晶钨(W)中氘保留的影响。使用扫描电子显微镜(SEM)观察表面形态,并使用热脱附光谱仪(TDS)测量辐照样品中的氘保留。结果表明,在大约400-500 K的底物温度下,表面出现了密集的高圆顶状水泡,氘的保留量也达到了最大值。然后水泡变得更低且稀疏,最后在900 K时消失。此外,D保留量在700 K以上时降低到相当低的水平。辐照样品中氘的热解吸谱图显示四个峰值温度是底物温度的函数在照射过程中,表明捕获部位的类型不同。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号