Fast brazing development for the joining of the beryllium armour layer for the ITER first wall panels

摘要

This paper describes the development of a flat pancake inductor for brazing beryllium tiles on a primary first wall (PFW) panel heat sink as well as the development of the brazing parameters. Two main variables were tested: brazing filler metal on one hand and PVD coating material on beryllium tiles on the other hand. The nickel coating and silver base brazing filler metal was the best couple and obtained shear values higher than 100 MPa. The inductor design and the choice of materials were applied to the brazing of a mock-up for high heat flux testing. Some tiles sustained 1000 cycles at 1.5 MW.