首页> 外文期刊>The Cryosphere >Wave energy attenuation in fields of colliding ice floes – Part 1: Discrete-element modelling of dissipation due to ice–water drag
【24h】

Wave energy attenuation in fields of colliding ice floes – Part 1: Discrete-element modelling of dissipation due to ice–water drag

机译:碰撞冰絮凝领域的波动能量衰减 - 第1部分:冰水拖曳因耗散的离散元素建模

获取原文
获取外文期刊封面目录资料

摘要

The energy of water waves propagating through sea ice is attenuated due to non-dissipative (scattering) and dissipative processes. The nature of those processes and their contribution to attenuation depends on wave characteristics and ice properties and is usually difficult (or impossible) to determine from limited observations available. Therefore, many aspects of relevant dissipation mechanisms remain poorly understood. In this work, a discrete-element model (DEM) is used to study one of those mechanisms: dissipation due to ice–water drag. The model consists of two coupled parts, a DEM simulating the surge motion and collisions of ice floes driven by waves and a wave module solving the wave energy transport equation with source terms computed based on phase-averaged DEM results. The wave energy attenuation is analysed analytically for a limiting case of a compact, horizontally confined ice cover. It is shown that the usage of a quadratic drag law leads to non-exponential attenuation of wave amplitude a with distance x, of the form a(x)=1/(αx+1/a0), with the attenuation rate α linearly proportional to the drag coefficient. The dependence of α on wave frequency ω varies with the dispersion relation used. For the open-water (OW) dispersion relation, α~ω4. For the mass loading dispersion relation, suitable for ice covers composed of small floes, the increase in α with ω is much faster than in the OW case, leading to very fast elimination of high-frequency components from the wave energy spectrum. For elastic-plate dispersion relation, suitable for large floes or continuous ice, α~ωm within the high-frequency tail, with m close to 2.0–2.5; i.e. dissipation is much slower than in the OW case. The coupled DEM–wave model predicts the existence of two zones: a relatively narrow area of very strong attenuation close to the ice edge, with energetic floe collisions and therefore high instantaneous ice–water velocities, and an inner zone where ice floes are in permanent or semi-permanent contact with each other, with attenuation rates close to those analysed theoretically. Dissipation in the collisional zone increases with an increasing restitution coefficient of the ice and with decreasing floe size. In effect, two factors contribute to strong attenuation in fields of small ice floes: lower wave energy propagation speeds and higher relative ice–water velocities due to larger accelerations of floes with smaller mass and more collisions per unit surface area.
机译:由于非耗散(散射)和耗散过程,通过海冰传播的水波的能量被衰减。这些过程的性质及其对衰减的贡献取决于波形特征和冰属性,并且通常难以(或不可能)来确定可用的有限观察结果。因此,相关耗散机制的许多方面仍然明白。在这项工作中,使用离散元素模型(DEM)来研究其中一个机制:由于冰水阻力而耗散。该模型由两个耦合部件组成,DEM模拟由波的冰浮动的浪涌运动和碰撞以及利用基于相位平均的DEM结果计算的源术语的波模块求解波能量传输方程。分析波能量衰减以分析用于紧凑,水平限制冰盖的限制性情况。结果表明,二次拖拉法的使用导致具有距离X的波幅A的非指数衰减,其形式A(x)= 1 /(αx+ 1 / A0),衰减率α线性比例拖动系数。 α对波频率ω的依赖性随着所使用的色散关系而变化。对于开放水分(OW)色散关系,α〜ω4。对于质量加载分散关系,适用于小氟纤维组成的冰盖,α的α增加远比在欧况中快得多,从而远离波能量谱的高频分量非常快。适用于弹性板分散关系,适用于大絮凝物或连续冰,高频尾部α〜ωm,M接近2.0-2.5;即,耗散比在案例中慢得多。耦合的DEM-波模型预测了两个区域的存在:靠近冰边的非常强烈的衰减面积,具有能量的剥落碰撞,因此高瞬时冰水速度,以及冰絮凝永久的内部区域或者彼此半永久接触,理论上分析的衰减率接近的速率。碰撞区的耗散随着冰的恢复系数越来越大,剥落尺寸减小。实际上,两个因素有助于在小冰絮凝物领域的强烈衰减:由于较大的氟于质量较大的絮凝物的较大加速度和每个单元表面区域的碰撞较大,相对冰水速度更高。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号