首页> 外文期刊>Chinese Journal of Systems Engineering and Electronics >UBSS and blind parameters estimation algorithms for synchronous orthogonal FH signals
【24h】

UBSS and blind parameters estimation algorithms for synchronous orthogonal FH signals

机译:同步正交跳频信号的UBSS和盲参数估计算法

获取原文
获取原文并翻译 | 示例
           

摘要

By using the sparsity of frequency hopping (FH) signals, an underdetermined blind source separation (UBSS) algorithm is presented. Firstly, the short time Fourier transform (STFT) is performed on the mixed signals. Then, the mixing matrix, hopping frequencies, hopping instants and the hooping rate can be estimated by the K-means clustering algorithm. With the estimated mixing matrix, the directions of arrival (DOA) of source signals can be obtained. Then, the FH signals are sorted and the FH pattern is obtained. Finally, the shortest path algorithm is adopted to recover the time domain signals. Simulation results show that the correlation coefficient between the estimated FH signal and the source signal is above 0.9 when the signal-to-noise ratio (SNR) is higher than 0 dB and hopping parameters of multiple FH signals in the synchronous orthogonal FH network can be accurately estimated and sorted under the underdetermined conditions.
机译:通过使用跳频(FH)信号的稀疏性,提出了不确定的盲源分离(UBSS)算法。首先,对混合信号执行短时傅立叶变换(STFT)。然后,可以通过K-means聚类算法估计混合矩阵,跳跃频率,跳跃时刻和跳跃率。利用估计的混合矩阵,可以获得源信号的到达方向(DOA)。然后,将FH信号分类并获得FH图案。最后,采用最短路径算法恢复时域信号。仿真结果表明,当信噪比(SNR)大于0 dB时,估计的FH信号与源信号之间的相关系数大于0.9,同步正交FH网络中多个FH信号的跳变参数可以为在不确定的条件下进行准确的估计和排序。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号