基于射频信号2阶零功率的链路色散测量技术

摘要

In order to meet the need of precise compensation of chromatic dispersion in optical fiber link with long distance and high bit rate, channel dispersion measurement technique based on second order lowest power of radio frequency (RF) signal was studied and demonstrated.The chromatic dispersion in optical fiber link was measured by the phase difference between RF signals that loaded to two sidebands of spectrum.By loading RF signal on the transmitter, the periodic relationship between the power of RF signal in the receiver and optical fiber dispersion was obtained.The position of second lowest RF signal power was gotten by simulation of relationship curve between the power of RF signal in the receiver and optical fiber dispersion.The results show that, the dispersion measuring error in this system is in the range of ±10ps/nm.Comparing with the technique based on first order lowest power of RF signal, dispersion measuring technique based on second order lowest power of RF signal can satisfy the need of measuring large fiber dispersion for high chromatic dispersion value.%为了适应高速率大色散光纤信道对链路色散的精确补偿要求,研究并提出了一种基于射频信号2阶零功率点的信道色散测量方案.采用信号两边带的位相差来测量光纤链路中的色散值,通过在发射端加载射频信号,可以得到接收端射频信号功率大小随链路色散值的周期性变化关系,从仿真光纤链路色散随射频信号频率的变化曲线获得接收端射频信号2阶零功率点位置.结果表明,基于射频信号2阶零功率的信号测量方案色散测量误差可控制在±10ps/nm范围内.相较于1阶零功率点,基于射频信号2阶零功率点信道色散测量方案可满足高速率、长距离大色散光纤信道对色散值的精确测量需求.