The experimental study on the melting of potassic basalt and eclogite with about 2% waterat 800-1300℃ and 1.0-3.5 GPa shows that the solidi of both rocks are significantly lower thanthose obtained from the previous experiments of the same type of rocks under dry conditions,and the former which is enriched in potassium has a lower melting point than the latter. It is con-sistent with the previous study. The melting temperature of eclogite increases with pressure,whereas potassic basalt has similar properties only at 1.5—2.5 GPa and3.0 GPa, and at 2.5—3.0 GPa the melting temperature decreases with pressure. This can be explained as follows: (1)eclogite only has one hydrous mineral amphibole and the dehydous temperature is lower than thewet solidus of the rock. (2) Amphibole exists in potassic basalt at the pressures lower than 2.5GPa and phlogopite exists at pressures higher than 2.5 GPa, and the special compositions of bothminerals determine that amphibole has a dehydration temperature higher than or close to that ofthe wet solidus of the rocks, while phlogopite has a dehydration temperature lower than that ofthe wet solidus. On the other hand the features of the continuous solidus in the experiment ofhydrous eclogite were produced by the fact that the dehydration temperature of its amphibolelower than or close to the melting temperature of the hydrous conditions. So the melting tempera-ture lowers at higher pressures. Therefore, the composition of the rocks in the lithosphere and thetypes of hydrous minerals and their stable P-T conditions are the important factors controllingthe solidi of rocks. It can quite well explain the partial melting of rocks and the origin of the lowvelocity zone in the deep lithosphere.
展开▼
