首页> 外文学位 >Modulation of selectivity between copper and zinc minerals using electrochemical potential of the pulp.
【24h】

Modulation of selectivity between copper and zinc minerals using electrochemical potential of the pulp.

机译:利用纸浆的电化学势调节铜和锌矿物之间的选择性。

获取原文
获取原文并翻译 | 示例

摘要

Electrochemical effects occurring in the processing of the A-1 zone copper-zinc-silver-pyrite ore from Les Mines Selbaie, Joutel, Québec, were investigated and correlated with the redox potentials measured in flotation pulps using a gold sensing electrode. On-line pulp potential measurements at the head of the copper flotation circuit were performed over a period of nearly one year. Windows of selectivity between the copper and zinc minerals were observed but the leading edge, and the width of the window were affected by the state of the sensor. Procedures for the verification of the state of the on-line sensor were established to ensure long term reliability of sensor. Sensitivity analysis of the pulp potential to modifiers, such as lime and sodium cyanide, suggested that these reagents could be controlled using the measured pulp potential to maintain the oxidation-reduction state of the pulp within the window of selectivity. A shorter study at the Kidd Creek concentrator indicated the presence of a window of selectivity between copper and zinc minerals but the leading edge and width of the window were different than that observed at Les Mines Selbaie. This suggests that the windows of selectivity are affected by ore and plant specific variables.; Laboratory investigations on feed pulp samples demonstrated that collectorless flotation of the copper minerals was a significant contributor to copper recovery in the A-1 zone circuit. Unfortunately, collectorless copper recovery was limited to around 60% and only a small proportion of the silver could be recovered in this fashion. The addition of collectors such as Aerophine 3418A (sodium di-isobutyl dithiophosphinate) or sodium isopropyl xanthate (SIPX) was required to achieve high recoveries but the selectivity response of these two collectors was different. The selectivity obtained with SIPX could be manipulated by modulation of the pulp potential before or after introduction of the collector. However, Aerophine 3418A exhibited an irreversibility in that an oxidation of the pulp before its introduction usually lead to a decreased selectivity even if the pulp potential was reduced prior to flotation.
机译:研究了魁北克Les Mines Selbaie,Joutel,魁北克Les Mines Selbaie的A-1区铜-锌-银-黄铁矿矿石加工过程中发生的电化学效应,并将其与使用金感测电极在浮选矿浆中测得的氧化还原电位相关联。在线浮选电路顶部的纸浆电势测量进行了将近一年的时间。观察到铜和锌矿物质之间选择性的窗口,但前缘和窗口的宽度受传感器状态的影响。建立了在线传感器状态验证程序,以确保传感器的长期可靠性。对纸浆电位对改性剂(例如石灰和氰化钠)的敏感性分析表明,可以使用测得的纸浆电位来控制这些试剂,以在选择性窗口内维持纸浆的氧化还原状态。在Kidd Creek选矿厂进行的一项较短的研究表明,铜和锌矿物质之间存在选择性的窗口,但该窗口的前沿和宽度与Les Mines Selbaie观察到的有所不同。这表明选择性窗口受矿石和工厂特定变量的影响。对饲料浆样品的实验室研究表明,铜矿物质的无收集器浮选是A-1区回路中铜回收的重要因素。不幸的是,无收集器的铜回收率被限制在60%左右,并且只能以这种方式回收一小部分的银。为了获得高回收率,需要添加收集器,例如Aerophine 3418A(二异丁基二硫代次膦酸钠)或异丙基黄原酸钠(SIPX),但是这两个收集器的选择性响应是不同的。用SIPX获得的选择性可以通过在引入收集器之前或之后调节纸浆电位来控制。但是,Aerophine 3418A具有不可逆性,因为即使在浮选之前降低了纸浆的电势,在引入纸浆之前氧化纸浆通常也会导致选择性降低。

著录项

  • 作者

    Labonte, Germain.;

  • 作者单位

    McGill University (Canada).;

  • 授予单位 McGill University (Canada).;
  • 学科 Engineering Metallurgy.; Engineering Mechanical.
  • 学位 Ph.D.
  • 年度 1999
  • 页码 258 p.
  • 总页数 258
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 冶金工业;机械、仪表工业;
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号