首页> 外文学位 >A comparison of production, costs, and stand impacts among four yarding methods.
【24h】

A comparison of production, costs, and stand impacts among four yarding methods.

机译:四种装料方式之间的产量,成本和林分影响的比较。

获取原文
获取原文并翻译 | 示例

摘要

An empirical time study was conducted to compare productivity and cost (stump to truck), effects on the residual trees and on the soil of four yarding methods - a forwarder following an in-woods processor, and a farm tractor, bulldozer, and rubber-tired cable skidder following manual felling - in a group selection harvest of a mixed hardwood stand in Maine.;A sensitivity analysis was applied to study differences between yarding machines costs in two different scenarios, one for old machines and other for new machines. Results indicated that the total machine cost and yarding cost for old machines were lower than the new machines. For old machines, the yarding cost was lowest for the forwarder method (;The farm tractor, bulldozer and skidder methods were associated with greater numbers of damaged trees per meter of yarding trail length. The skidder method resulted in the highest number of trees with bole damage, while forwarder caused the lowest. The tractor method resulted in the most root damage and the forwarder method resulted in the largest trail width. In addition, the bulldozer method resulted in the largest number of damaged boles per 100 m² of near trail space, while the forwarder method was associated with smallest number of damaged boles per 100 m².;The bulldozer and forwarder systems were associated with the highest and lowest soil bulk density measured in machine tracks, in trail centerlines, and harvested group selection units vs. adjacent untrafficked areas, respectively.;While, overall, the forwarder was considerably more productive, caused only slightly more residual stand damage, less soil compaction, and was less expensive on a cost per cubic meter basis. However, its larger size, wider turning radius, and high capital investment, especially when coupled with an in-woods processor, and moving costs suggest caution when considering a forwarder, especially for the harvest of relatively small nonindustrial private forests characteristic of much of the region.
机译:进行了一项经验时间研究,以比较生产力和成本(从树桩到卡车),四种堆放方法对残留树木和土壤的影响-四种操作方法是:在木材加工机之后的货运代理,以及农用拖拉机,推土机和橡胶-人工采伐后疲倦的电缆打滑机-在缅因州的一组混合硬木林分群收获中进行;敏感性分析用于研究两种不同情况下堆放机成本之间的差异,一种是旧机器,另一种是新机器。结果表明,旧机器的总机器成本和堆放成本低于新机器。对于旧机器,货代方法的堆放成本最低(;农用拖拉机,推土机和集材机方法与每米堆放步道长度的受损树木数量更多相关。集材机方法导致带树桩的树木数量最多损坏,而货运代理造成的损坏最小,拖拉机方法导致最大的根部损坏,货运代理方法导致的履带宽度最大,此外,推土机方法导致每100平方米的靠近履带空间的损坏的猪骨数量最多,而推土机方法与每100平方米损坏的猪眼数量最少相关。;推土机和推土机系统与在机器航迹,步道中心线以及收获的组选择单位与相邻未贩运车辆中测得的最高和最低土壤容重相关总体而言,货运代理的生产率更高,仅造成稍多的剩余林分损害,更少的土壤堆肥而且每立方米的成本也较便宜。但是,它的尺寸更大,转弯半径更宽,投资成本较高,尤其是在与林内加工机结合使用时,以及搬迁成本,建议在考虑货运代理时尤其要谨慎,尤其是对于采伐相对较小的非工业私有林而言,这是许多伐木场的特征。区域。

著录项

  • 作者

    Bustos-Letelier, Oscar.;

  • 作者单位

    The University of Maine.;

  • 授予单位 The University of Maine.;
  • 学科 Agriculture Forestry and Wildlife.;Natural Resource Management.
  • 学位 Ph.D.
  • 年度 2012
  • 页码 101 p.
  • 总页数 101
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号