首页> 外文会议>International workshop on information data storage >An efficiency-enhanced 2X/1.5X SC charge pump with auto-adjustable output regulation for PCM
【24h】

An efficiency-enhanced 2X/1.5X SC charge pump with auto-adjustable output regulation for PCM

机译:一种效率增强的2倍/ 1.5X SC电荷泵,具有自动调节的PCM输出调节

获取原文

摘要

This paper presents a 2X/1.5X switched-capacitor charge pump for phase change memory (PCM). For a 16-bit-parallelism PCM, the set/reset time is more than 100 ns, and the charge pump should output a minimum 60 mA load current. The proposed charge pump can supply 4.1 V voltage and 0-60 mA current for PCM, with an input voltage range of 2.2-3.5 V. It can also automatically change the power conversion ratio between the 2X/1.5X modes according to input voltage. For the improvement of efficiency and load transient response, an auto-adjustable output regulation scheme is employed. In this scheme, two new reference voltages are introduced and compared with output voltage. Average lasting time of the enable signal changes under different load conditions. The Enable signal then controls booster's power transistors switching to regulate output voltage. In this way, output voltage was controlled within a permissible range. The charge pump has been designed and simulated in a 40nm CMOS process. The results show maximum power efficiency in 30 mA load current is 90.73%, and conversion ratio control increases the efficiency by 23.06% in 3 V.
机译:本文介绍了一个2×/ 1.5x开关电容电荷泵,用于相变内存(PCM)。对于16位并行性PCM,设定/复位时间大于100 ns,电荷泵应输出最小60 mA负载电流。所提出的电荷泵可以为PCM提供4.1V电压和0-60 mA电流,输入电压范围为2.2-3.5 V.它还可以根据输入电压自动改变2×/ 1.5x模式之间的电源转换比率。为了提高效率和负载瞬态响应,采用自动调节输出调节方案。在该方案中,引入并与输出电压进行了两台新的参考电压。使能信号的平均持续时间在不同的负载条件下变化。然后,使能信号控制增压器的功率晶体管切换以调节输出电压。以这种方式,在允许范围内控制输出电压。电荷泵已经在40nm CMOS工艺中设计和模拟。结果表明,30 mA负载电流的最大功率效率为90.73%,转换比控制在3 V中将效率提高23.06%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号