Assessing biofouling on polyamide reverse osmosis (RO) membrane surfaces in a laboratory system

摘要

Biofouling of reverse osmosis (RO) membranes is a major impediment in both wastewater reuse and desalination of sea/brackish waters. A benefit to the industry would be a simple screening approach to evaluate biofouling resistant RO membranes for their propensity to biofoulants. To observe the relationship between initial membrane productivity and control of biofilm formation governed by surface modification to the aromatic polyamide thin-film composite RO membranes, three different RO membranes developed by the FilmTec Corporation including FilmTec's commercial membrane BW30 (RO#1) and two experimental membranes (RO #2 and #3) were used. RO #2 and RO #3 were modified with a proprietary aliphatic group and with an extra proprietary aromatic group, respectively. Membrane swatches were fixed on coupons in rotating disk reactor systems without filtration and exposed to water with indigenous organisms supplemented with 1.5 mg/L organic carbon under continuous flow. After biofouling had developed, the membranes were sacrificed and subjected to several analyses. Staining and epifluorescence microscopy revealed more cells on RO #2 and #3 compared to RO #1. Based on image analysis of 5-mu m thick stained biofoulant cryo-sections, the accumulation of hydrated biofoulants on RO #1 and #3 were from 0.87 to 1.26 mu m/day, which was lower than that on RO#2 (2.19 mu m/day). Biofoulants increased the hydrophobicity of RO #2 to the greatest amount, up to 32 degrees, as determined by contact angle. In addition, a wide range of changes of the chemical elements of the RO surfaces was observed with X-ray photoelectron spectroscopy analysis. RO #2 with the highest initial membrane productivity showed the poorest biofouling resistance. A combination of these novel approaches showed good agreement and suggested that membrane productivity, heterogeneity of anti-biofouling agents on membrane surface, stability of surface chemical elements and the role of virgin RO surface hydrophobicity should be jointly considered during the development of anti-biofouling polyamide thin-film RO surfaces. Published by Elsevier B.V.