...
首页> 外文期刊>Solar Energy >Thermal stability of the DSC ruthenium dye C106 in robust electrolytes
【24h】

Thermal stability of the DSC ruthenium dye C106 in robust electrolytes

机译:DSC钌染料C106在坚固电解质中的热稳定性

获取原文
获取原文并翻译 | 示例
           

摘要

We have investigated the thermal stability of the heteroleptic ruthenium complex C106 employed as a sensitizer in dye-sensitized solar cells. The C106 was adsorbed on TiO2 particles and exposed to 2 different iodide/triidode based redox electrolytes A and B at 80 degrees C for up to 1500 h in sealed glass ampules. Both electrolytes contain guanidiniumthiocyanate (GuNCS) and N-butylbenzimidazole (NBB) as additives. Electrolyte A: 1,3-dimethylimidazolium iodide (1.0 M), I-2 (0.15 M), NBB (0.5 M), and GuNCS (0.1 M) in methoxypropionitrile and electrolyte B: 1,3-dimethylimidazolium iodida1-ethy1-3-methylimidazolium iodide/1-ethyl-3-methylimidazolium iodide/I-2/NBB/GuNCS (molar ratio: 12/12/16/1.67/3.33/0.67) and sulfolane (1:1 v/v). The samples were prepared either in ambient air or under strict atmospheric moisture control in a glove box We extracted samples of the dispersion at regular intervals desorbed the dye from the TiO2 particles and analyzed its by HPLC coupled to UV/Vis and electro spray mass spectrometry. Samples prepared in the glove box gave the highest stability with a steady state photo anode surface concentration of 80% C106 intact and the remaining similar to 20% being the N-butylbenzimidazole (NBB) substitution products 3 and 4 formed by replacement of the thiocyanate ligand by NBB after 1500 h of heating at 80 degrees C. Samples prepared under ambient conditions gave a steady state C106 concentration of 60% of the initial value and 40% substitution products. The C106 degradation was found to be independent of the degree of dye loading of the TiO2 particles and the ratio between the amount of dyed TiO2 particles and electrolyte volume. Assuming that this substitution is the predominant loss mechanism in a DSC during thermal stress, we estimate the reduction in the DSC efficiency after long term heat to be 12-24% depending on the degree of atmospheric control during the DSC fabrication. (C) 2014 Elsevier Ltd. All rights reserved.
机译:我们已经研究了在染料敏化太阳能电池中用作敏化剂的杂钌复合物C106的热稳定性。将C106吸附在TiO2颗粒上,并在密封的玻璃安瓿瓶中于80摄氏度下暴露于2种不同的基于碘化物/三碘化物的氧化还原电解质A和B长达1500 h。两种电解质均包含硫氰酸胍(GuNCS)和N-丁基苯并咪唑(NBB)作为添加剂。电解质A:甲氧基丙腈和电解质B中的1,3-二甲基咪唑碘化物(1.0 M),I-2(0.15 M),NBB(0.5 M)和GuNCS(0.1 M)B:1,3-二甲基咪唑碘化物1-ethy1-3 -甲基碘化咪唑鎓/ 1-乙基-3-甲基碘化咪唑鎓/ I-2 / NBB / GuNCS(摩尔比:12/12/16 / 1.67 / 3.33 / 0.67)和环丁砜(1:1 v / v)。样品是在环境空气中或在严格的湿度控制下在手套箱中制备的。我们以规则的时间间隔提取分散体的样品,从TiO2颗粒中解吸染料,并通过HPLC与UV / Vis和电喷雾质谱联用对其进行分析。在手套箱中制备的样品具有最高的稳定性,稳态光阳极表面浓度完整无缺(C106)为80%,其余的20%是通过取代硫氰酸酯配体形成的N-丁基苯并咪唑(NBB)取代产物3和4。在80℃加热1500 h后,用NBB用NBB进行分析。在环境条件下制备的样品的稳态C106浓度为初始值的60%,替代产物为40%。发现C106的降解与TiO 2颗粒的染料负载程度以及染色的TiO 2颗粒的量与电解质体积之间的比率无关。假设这种替代是热应力过程中DSC的主要损耗机理,我们估计长期加热后DSC效率的降低为12-24%,具体取决于DSC制造过程中的气氛控制程度。 (C)2014 Elsevier Ltd.保留所有权利。

著录项

  • 来源
    《Solar Energy》 |2014年第12期|96-104|共9页
  • 作者单位

    Roskilde Univ, Dept Sci Syst & Models, DK-4000 Roskilde, Denmark;

    Roskilde Univ, Dept Sci Syst & Models, DK-4000 Roskilde, Denmark|Vietnam Natl Univ, Univ Sci, Fac Chem, Ho Chi Minh City, Vietnam;

    Roskilde Univ, Dept Sci Syst & Models, DK-4000 Roskilde, Denmark;

    Swiss Fed Inst Technol, Lab Photon & Interfaces, CH-1015 Lausanne, Switzerland;

    Swiss Fed Inst Technol, Lab Photon & Interfaces, CH-1015 Lausanne, Switzerland;

    Swiss Fed Inst Technol, Lab Photon & Interfaces, CH-1015 Lausanne, Switzerland;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Dye-sensitized solar cells; Thermal stability of sensitizer; C106; Ionic liquid electrolytes; LC-MS;

    机译:染料敏化太阳能电池;敏化剂的热稳定性;C106;离子液体电解质;LC-MS;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号