首页> 外文期刊>Solar Energy >Influence of required tank water temperature on the energy performance and water withdrawal potential of a solar water heating system equipped with a heat pipe evacuated tube collector
【24h】

Influence of required tank water temperature on the energy performance and water withdrawal potential of a solar water heating system equipped with a heat pipe evacuated tube collector

机译:所需水箱水温对装有热管真空管集热器的太阳能热水系统的能量性能和取水潜力的影响

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

Hot water is a key demand of many industrial and domestic heating systems. This demand is, however, variable, both in terms of when hot water is needed, and the water temperature required. The present work examines the use of solar energy as an alternative means of producing hot water. A solar water heating system (SWH) with a heat pipe evacuated tube collector (ETC) was designed, and the effect of the required tank water temperature (rTWT) on the energy performance of the system examined. The maximum quantity of withdrawable hot water was also determined. The results show that, as rTWT increases, the net energy that can be stored by the system falls, with differences of over 1000 W h m(-2) d(-1) between rTWTs of 40 degrees C and 80 degrees C at a solar radiation input of 8000 W h m(-2) d(-1) (system efficiency range 56-73%). This reduction is a consequence of the decreasing collector efficiency and increasing energy losses in the circuit's tubing with increasing rTWT. The higher the rTWT, the more solar radiation is required for the first discharge of hot water to take place (6500 W h m(-2) d(-1) for 80 degrees C). In addition, the time between discharges increases, and therefore the number of discharges possible over the day decreases. As rTWT increases, the amount of hot water discharged falls, the consequence of falling collector efficiency and the greater energy content of the water, etc. This reduction fits a power curve for which R-2 = 0.99: over 300 L m(-2) d(-1) are produced for an rTWT of 40 degrees C, but just 20 L m(-2) d(-1) for one of 80 degrees C (global efficiency 62% and 21% respectively). For an rTWT of 80 degrees C, an important percentage of the incoming energy would accumulate in the water tank as hot water, but without the required temperature being reached. Auxiliary systems would be required to profit from this energy, which should be used as soon as possible; certainly, nocturnal heat losses from the tank would considerably reduce the amount available if this water were not used until the next day. The viability of this type of installation as a sole provider of hot water is therefore reduced drastically as the rTWT increases. (C) 2014 Elsevier Ltd. All rights reserved.
机译:热水是许多工业和家庭供暖系统的关键需求。但是,无论何时需要热水和所需水温,该需求都是可变的。本工作研究了将太阳能用作产生热水的替代方法。设计了带有热管真空管集热器(ETC)的太阳能热水系统(SWH),并检查了所需水箱水温(rTWT)对系统能量性能的影响。还确定了可抽出热水的最大量。结果表明,随着rTWT的增加,系统可存储的净能量下降,在40摄氏度和80摄氏度的rTWT之间,太阳能之间的差异超过1000 W hm(-2)d(-1)。辐射输入为8000 W hm(-2)d(-1)(系统效率范围为56-73%)。这种减少是由于收集器效率降低和回路管路中的能量损失随rTWT的增加而增加的结果。 rTWT越高,第一次进行热水排放就需要越多的太阳辐射(对于80摄氏度,为6500 W h m(-2)d(-1))。另外,放电之间的时间增加,因此一天中可能的放电次数减少。随着rTWT的增加,排出的热水量将下降,集热器效率下降和水的能量含量降低的结果,等等。这种降低符合R-2 = 0.99的功率曲线:超过300 L m(-2 )d(-1)是针对40摄氏度的rTWT而产生的,而对于80摄氏度的其中之一仅产生20 L m(-2)d(-1)(全局效率分别为62%和21%)。对于80摄氏度的rTWT,大部分的输入能量将作为热水积聚在水箱中,但没有达到所需的温度。需要使用辅助系统以从这种能量中获利,应尽快使用;当然,如果直到第二天才使用这种水,那么水箱的夜间热量损失将大大减少可用水量。因此,随着rTWT的增加,这种类型的设备作为热水的唯一提供者的可行性大大降低。 (C)2014 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号