首页> 外文期刊>Fuel >Effects of carbon dioxide and nitrogen addition on soot processes in laminar diffusion flames of ethylene-air at high pressures
【24h】

Effects of carbon dioxide and nitrogen addition on soot processes in laminar diffusion flames of ethylene-air at high pressures

机译:高压下乙烯-空气层流扩散火焰中二氧化碳和氮的添加对烟灰过程的影响

获取原文
获取原文并翻译 | 示例
       

摘要

An experimental assessment of the influence of carbon dioxide and nitrogen dilution on sooting characteristics of laminar ethylene diffusion flames at pressures up to 20 atm is presented. Two dilution rates, defined as the ratio of mass flow of the fuel to that of the diluent gas, of 1:2 and 1:3 were used at all pressures with a fixed ethylene mass flow rate. A wider range of nitrogen dilution, from 1:1 to 1:4, was investigated at 10 atm. In the pressure range of interest and with the mass flow rates of fuel and diluents, resulting flames were stable and nonsmoking. Spectrally-resolved line-of-sight soot radiation measurements were obtained to infer the radial soot and temperature distributions within the flame envelope through an Abel inversion process. The sooting propensity, in terms of maximum soot yield, was found to be significantly lower with carbon-dioxide dilution in the pressure range of 1-15 atm but approached to comparable values to those with nitrogen-dilution at 20 atm. The implication of this finding is that the chemical suppression effect of carbon dioxide dilution, which was proven at atmospheric pressure previously, exists also at elevated pressures up to 15 atm and becomes relatively small at higher pressures. Variation of the maximum soot yields with pressure indicated that carbon dioxide-diluted flames show a relatively stronger dependence to pressure as compared to nitrogen-diluted flames. Temperatures decreased with increasing pressure as expected due to increasing, radiative heat loss, and the peak temperatures were observed near the flame tips as a result of the heat release from soot oxidation. (C) 2017 Elsevier Ltd. All rights reserved.
机译:实验评估了二氧化碳和氮气稀释对高达20 atm的压力下层状乙烯扩散火焰的烟so特性的影响。在所有压力下,以固定的乙烯质量流量,使用两种稀释率,即燃料与稀释气体的质量流量之比,分别为1:2和1:3。在10个大气压下研究了更广泛的氮稀释范围,从1:1到1:4。在目标压力范围内以及燃料和稀释剂的质量流率下,产生的火焰稳定且无烟。获得了光谱分辨的视线烟尘辐射测量值,以通过Abel反演过程推断火焰包络内的径向烟尘和温度分布。发现在最大二氧化碳排放量的情况下,在压力范围为1-15 atm的二氧化碳稀释下,碳烟倾向明显降低,但与在20 atm进行氮气稀释的情况相近。这一发现的含义是,二氧化碳稀释的化学抑制作用(先前已在大气压下证明)也存在于高达15atm的高压下,并且在高压下相对较小。最大碳烟产量随压力的变化表明,与用氮气稀释的火焰相比,用二氧化碳稀释的火焰对压力的依赖性更大。由于辐射热损失的增加,温度随压力的增加而降低,并且由于烟灰氧化释放的热量,在火焰尖端附近观察到峰值温度。 (C)2017 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号