首页> 外文期刊>ACS Omega >Novel Method for Inverted Five-Spot Reservoir Simulation at High Water-Cut Stage Based on Time-Varying Relative Permeability Curves
【24h】

Novel Method for Inverted Five-Spot Reservoir Simulation at High Water-Cut Stage Based on Time-Varying Relative Permeability Curves

机译:基于时变相对渗透曲线的高污水阶段倒五点储层模拟的新方法

获取原文
           

摘要

After large-scale and long-term waterflooding, reservoir physical properties such as the pore throat structure and rock wettability may change. In this paper, the relative permeability curves under different water injection volumes through core-flood experiments were used to characterize the comprehensive changes of various reservoir physical properties at high water-cut stage. The novel concept of “water cross-surface flux” was proposed to characterize the cumulative flushing effect on the reservoir by injected water, and a novel method for inverted five-spot reservoir simulation at high water-cut stage based on time-varying relative permeability curves was established. From the relative permeability curves measured through two cores from the X oilfield under different water injection volumes (100, 500, 1000, 1500, and 2000 PV), it is found that with the increase of injected water volume, the two-phase co-flow zone becomes wider, the water permeability under residual oil saturation increases, and the residual oil saturation decreases. A waterflooding core model was established, simulated, and verified by the method proposed in this paper. It is found that using time-varying permeability curves for simulation, the highest oil recovery factor (61.58%) can be obtained with injected water volume up to 2000 PV, and the purpose of improved oil recovery (IOR) can be achieved by high water injection volume, but the increment is only approximately 10%. Besides, a waterflooding model of an inverted five-spot reservoir unit based on the X oilfield was also established, simulated, and analyzed. Simulation results have shown that no matter which set of core permeability curves measured from 100 to 2000 PV is directly used alone, the oil recovery factor will be simulated inaccurately. The findings of this study can help in better understanding the quantitative description of the oil recovery changes with time-varying reservoir physical properties in high water-cut reservoirs during waterflooding.
机译:经过大规模和长期的水塑化,储层物理性质如孔喉部结构和岩石润湿性可能会发生变化。本文通过核心洪水实验采用不同注水体积的相对渗透曲线来表征高污水阶段各种储层物理性质的综合变化。 “水跨表面通量”的新颖概念被提出通过注入水对储存器的累积冲洗效果,以及基于时变相对渗透率的高污水阶段倒五点储层模拟的新方法曲线是建立的。从不同的注水量(100,500,000,1500和2000 PV的X油田中通过两个芯测量的相对渗透曲线,发现随着注射水量的增加,两相共同流动区变宽,残留油饱和度下的水渗透性增加,残留的油饱和度降低。通过本文提出的方法建立,模拟并验证了水上核心模型。结果发现,利用时间变化的渗透曲线进行模拟,可以通过注入的水体积获得最高的储存因子(61.58%),其注入水体积高达2000级,并且通过高水可以实现改善的储油(IOR)的目的注射体积,但增量仅为约10%。此外,还建立,模拟和分析了基于X油田的倒五点储层单元的倒五点储层单元的水上模型。模拟结果表明,无论直接单独使用100〜2000pV的一组核心渗透曲线,都将不准确地模拟储油因子。该研究的结果可以帮助更好地理解储油变化的定量描述,随着水上水割储存器中的高污水储存器中的时变储层物理性质。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号