天然气水合物仅在相对低的温度和高压条件下稳定存在,一旦脱离其稳定条件就将分解成气体和水而不复存在,因此水合物样品的储存与制备等相关前处理过程对其气体组成的准确测定十分重要.本文实验研究了天然气水合物在常压条件下的最佳储存温度、最佳分解方法、分解气的最佳收集与储存方式,以及非水合物气体的排除等样品前处理技术.结果表明:天然气水合物在常压下低于-100℃储存为妥；样品在进行分解脱气时,“顶空法”和“注射器法”适用性较广,“排水法”不适用于含CO2的水合物样品,且样品分解前最好于-80℃放置片刻以去除表面吸附的非水合物气体.水合物分解气体的储存应尽量避免使用铝塑气袋,建议采用丁基橡胶塞密封的玻璃顶空瓶,并于5天内完成气体组成测定为佳.%Natural gas hydrate can only steadily exist at lower temperature and higher pressure, otherwise it will decompose into gas and water. Hereby, the pre-treatments (sample preservation, preparation, etc.) are very important to the accurate measurement of gas components of gas hydrate. Described in this paper are the pre-treatment technologies of gas hydrate that were studied experimentally, mainly including the optimal preservation temperature under atmospheric pressure, the optimal decomposition methods, the optimal ways of gas collecting and storing, and the removal methods of non-hydrate gases. The results indicate that the best temperature for gas hydrate storage is less than - 100℃ under atmospheric pressure. The headspace method and syringe method can be widely used in hydrate-bound gases' decomposition and collection, however, the drainage method was not suitable for hydrate samples containing CO2. It was more beneficial to place the sample at -80℃ to remove the non-hydrate gases absorbed on the surface of the specimen. In addition, the use of a glass bottle with butyl rubber plug for storage of hydrate decomposition gases instead of aluminum-plastic air bag is preferential, and the optimum time to finish the analysis of molecular compositions is within 5 days.
展开▼
