首页> 外文会议>Conference on Ph.D. Research in Microelectronics and Electronics >A low-noise K-band class-C VCO for E-band 5G backhaul systems in 55nm BiCMOS technology
【24h】

A low-noise K-band class-C VCO for E-band 5G backhaul systems in 55nm BiCMOS technology

机译:适用于采用55nm BiCMOS技术的E波段5G回程系统的低噪声K波段C类VCO

获取原文

摘要

Next-generation 5G communication systems require adaptive high-order modulations to increase spectral efficiency. To limit EVM, very low phase noise levels are required - i.e. less than -117dBc/Hz at 1MHz offset for 64QAM at f=20GHz. In this paper, the design and measurements of a low-noise K-Band VCO are presented. The challenges of achieving such a low phase noise are discussed in detail, with particular emphasis on the minimization of L/Q, inductor versus quality factor ratio. Prototypes have been realized in a 55nm BiCMOS technology. Operated at 2.5V supply with the largest amplitude allowed by reliability constraints, measurements show a phase noise as low as -119dBc/Hz at 1MHz from a 20GHz carrier offset with a tuning range (TR) of 19% and FoM=-187dBc/Hz. Power consumption is 56mW. To the best of authors' knowledge, the presented VCO shows the lowest reported phase noise among state-of-the-art BiCMOS VCOs with TR>10%.
机译:下一代5G通信系统需要自适应高阶调制来提高频谱效率。为了限制EVM,需要非常低的相位噪声水平-即对于f = 20GHz的64QAM,在1MHz偏移处小于-117dBc / Hz。本文介绍了低噪声K波段VCO的设计和测量。详细讨论了实现如此低的相位噪声的挑战,并特别强调了L / Q,电感与品质因数之比的最小化。原型已在55nm BiCMOS技术中实现。在2.5V电源下工作,具有可靠性限制所允许的最大幅度,测量显示,相位噪声在20MHz载波失调的1MHz处在1MHz时低至-119dBc / Hz,调谐范围(TR)为19%,FoM = -187dBc /赫兹。功耗为56mW。据作者所知,提出的VCO在TR> 10 \%的最新BiCMOS VCO中显示出最低的相位噪声。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号